- Blade was a recycled file 4 1/2”
- I used the conditioning belts on this knife.
Because this Antler Handled Carving Knife’s antler was put on with the base end first, it required a little different technique. It seems the base is bone and is harder. It did not soften like a cut end that exposes the softer insides. To get around this I drilled a hole then slightly widen it to be about the width of the tang. I drilled with a drill bit the approximate width and used a Dremel with a cutter to widen it.
I then boiled it again. This time for about 15 minutes.
I also had this antler soaking in water for several days before I was going to install it.