Category: Tools & Equipment

Beech Beam Compass

Beech Beam Compass It is shown with a 12″ beam but the beam is just a 1″ x 3/4″ piece of lumber It can be […]

I made this router lift over ten years ago. It started out in an old Craftsman Table saw. It then went into the top of […]

Bladesmithing – My Starter Tools, Jigs and Supplies post any questions or comments on the forum One of the questions I’m sure you’ll ask is […]

When I built my belt grinder i used a 2 hp single phase motor I had on hand. I wasn’t exactly sure how much I’d […]

DIY 2 x 72″ Belt Grinder I wanted to build a 2 x 72″ belt grinder. I did a bunch of research and formulated a […]

Here is my journey building my propane forge. I’m not looking at this as a coal forge replacement, but an addition to my blacksmithing tool […]

This is my make shift back yard red neck coal burning forge. What a learning experience this has been. This is an old wood stove […]

After my initial design and a few days of forging I decided it was time to make some major changes to the forge. I’ve left […]